Brand
UV Flexo ink solutions
Made in
Information is being updated ...
✓ Excellent adhesion properties
✓ 20-902 and 20-908: excellent shrink characteristics, more than 70% with
good retained adhesion (dependent on substrate and film weight)
✓ Steam or hot air shrink (20-902 & 20-908)
✓ High opacity
✓ Fast cure
✓ Excellent printability
SUBSTRATES
Suitable for a wide range of coated papers, films and label stocks such as:
✓ PE, PP, PVC, PET, and OPP
✓ 20-902 and 20-908: Shrink films, typically* PVC, PET, PET-G, OPS
* Due to the diverse nature of shrink films, it is essential that each grade/application is tested thoroughly prior to commercial production.
The suitability for uncoated synthetic substrates such as PP should be tested before printing. The surface tension should be 38 dyne/cm or above. Corona treatment should be considered to improve the wetting and adhesion on to the substrate.
APPLICATION
Mix well before use.
Anilox Selection:
120-180 l/cm (300-460 lpi) volume 6-12 cm3/m²
Minimum lamp power – 160 W/cm
Clean equipment immediately after use.
Fully cured UV flexo inks will obtain resistance properties 24 hours after printing.
Please be aware that the over curing of a product may lead to problems
with thermal transfer overprinting.
This ink series is not intended for food packaging applications.