Thương hiệu
Mực in Flexo
Sản xuất tại
Thông tin đang cập nhật ...
Excellent adhesion properties
Fast cure
Excellent printability
High brilliance/lustre
table one pack inks
SUBSTRATES
Suitable for a wide range of substrates including:
✓ Coated PE and PP
✓ Coated papers and board
The suitability of uncoated synthetic substrates such as PP should be tested before printing. The surface tension should be 38 dyne/cm or above. Corona treatment should be onsidered to improve the wetting and adhesion onto the substrate.
APPLICATION
Mix well before use.
Anilox Selection:
80-160 l/cm (200-400 lpi) volume 8-15 cm3/m²
Note: The increase of the high lustre metallic effect is relative to the increase
of film weight.
Minimum lamp power – 160 W/cm
Fully cured UV flexo inks will obtain resistance properties 24 hours after
printing.
Clean equipment immediately after use.
These products are not intended for food packaging applications.


